I have several low mileage CF 3102's and CM2020's that I'm parting out.
If anybody needs any
laser units
glass
top feeders
duplexs
optional drawers (even an LCT)
motors
Controller Boards (sorry Firey's are all gone. I have a couple Fiery's that turn on, but don't communicate with the contoller)
Control Panels
Or anything else let me know
This is the power supply that you are needing right? The power unit that the three 110 A/C plugs are in for the Fiery controller, scanner and the one for the wall outlet.
I have an Imagistics CM2020 (which is the CF2002 equivilant) that has a good power supply and has 84,000 copies on it.
OR if it has to be Minolta, I have a CF2002 good power supply with about 890,000 copies on it.
I hope I can describe this right. I repair computers for a living and bought this printer 2 months ago. 3 weeks after I bought it I walked into the office only to find it had a orange light on the start key and no power any where else. Many hours later I found a bad resister on the PU1 Board. This is the board located directly below the blue paper catch tray. It has the three 110 V plugs that plug into the board. However I just need the board and not the control unit that sits next to it. In the parts manual I believe the part is 4025-6201-02. I have searched for this part for sometime and can not find it. The printer in a minolta dialta cf2002.
O.k, going back through the parts manual, I can see that the part number that you have is correct for the NA verion (110) and they seem to be the same either way for the CF3102 or the CF2002.
I would like to be on the safe side and get you one that is specific for the CF2002 just to play it safe. I will get just the board and not the control unit for you if you would like it.
Linear Mode
