Spot the deliberate mistake

[minimerlin]

This machine has only just been through a refurb at our workshop..........some apprentice is going to get a kick from me in the morning!!WP_20160816_13_24_14_Pro.jpg

I was sent to look at the machine at the customer`s offices..it was jamming!

[Synthohol]

oh good lord. i wont even use those, all 3 get A00J563600's the finned ones wear out way too fast.
that's funny though.

[mo0651]

Paper requires some serious separation!

[copyman]

I thought this is how you get a machine to feed multi pages. Who needs separation !!!

I have used the ribbed rollers on the biz C203 series for the Pick up and they have worked much better than the original P/U roller. The K/M rollers wear out so fast. The service manual maint list has replacement for P/U, Feed & Sep done every 300,000. This is absurd! Lucky if you get 100,000 out of the original rollers.

Really strange is I have had the older B&W models, i.e. biz 200 series, etc that I never had to replace rollers in the paper drawers, only replaced the ADF rollers.

[ZOOTECH]

This machine has only just been through a refurb at our workshop..........some apprentice is going to get a kick from me in the morning!!WP_20160816_13_24_14_Pro.jpg

I was sent to look at the machine at the customer`s offices..it was jamming!

Wasn't it checked out before going to the customer's site? It seems to me that whomever was in charge of training this apprentice, might have left out a few tools (service manual, parts manual, tech bulletins) to be used when rebuilding. This was most likely not deliberate, but more likely a lack of training IMHO.
(three pick up rollers is kind of funny though - and I'm guessing that not one manufacturer uses that setup)

[ZOOTECH]

I did have a "fill-in set up tech" cut the 'remove this tag' (Sharp) by cutting the red ribbon, and not removing the 'lock down hardware'; 'help' does not always save you time.

[mikadonovan]

Lol. That's a powerful lot of pickup rollers for 1 feed unit

[mbcruzin]

This machine has only just been through a refurb at our workshop..........some apprentice is going to get a kick from me in the morning!!WP_20160816_13_24_14_Pro.jpg

I was sent to look at the machine at the customer`s offices..it was jamming!

bwahahahahahahahahahahahahahahahahahahahahahahaha [breath].....................[breath/] hahahahahahahahahahahahahahahahahahaha

[techwurk]

Ribbed for their jamming pleasure

[Woxner]

tell the newbie to sand the two rollers next time !!!!!!!!!! see what he says