Likes:
0
Dislikes:
0
-
MPC 3003 SC 204
This one has us stumped.
Basically, you can get the machine to come up. When you do test prints (I like using checker board), I can do black and each color and the machine will run and those prints look good (not faded or missing stuff, etc).
When you try an alignment either in SP mode or through the user maint, SC 204 pops up.
We have replaced the IOB, BCU, laser motor, laser housing unit, transfer belt unit. Firmware has been updated. We also cut wire ties on the harness between the connecters at the laser housing unit and the board.
On some older machines (MPC3300) a 204 had nothing to do with what the book said it did (laser error). It instead was a issue with grounding, especially on the door and with the transfer unit. I don't think that is the issue with this particular machine as we can get it to run doing test prints and it doesn't code out. Only when the alignment procedure is attempted.
-
Re: MPC 3003 SC 204
I'm not sure about the error code (not trained), but with the way the machine is acting you might want to check the ID sensors. Sounds like they can't see the color alignment pattern.
Sorry if you've already checked that.
-
Technician
- Rep Power
- 15
Re: MPC 3003 SC 204
i do have same problem.all board had been changed.but still appeared sc 204 when using rotate sort.plz do reply if had the solution...tq
-
Technician
- Rep Power
- 15
Re: MPC 3003 SC 204
hi all...today i just resolve my problem mpc3003 scc204.just change a unit LD.new in a box.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks