Ricoh SP C440

[Superbug]

Hello , I installed a new SP C440,but when I turned on the machine , the screen is off , the initial process seems to start , but then remain only the fans running .


I tried to install the firmware , but will not start the charging process .


Any solution?

[Debs1964]

Hello , I installed a new SP C440,but when I turned on the machine , the screen is off , the initial process seems to start , but then remain only the fans running .


I tried to install the firmware , but will not start the charging process .


Any solution?

Was there ever a resolution to this problem as I have one doing exactly the same thing.
There are lights on for the network, but cannot access WIM or ping device.

Hello, by the way, it’s been a long time...

[keithxxiii]

have you tried inspecting the fuse from the power supply?

[Debs1964]

have you tried inspecting the fuse from the power supply?

No, but PSU is top of my list for parts to order, I was hoping someone else had had this problem and knew what part(s) were needed

[anothertech]

Was there ever a resolution to this problem as I have one doing exactly the same thing.
There are lights on for the network, but cannot access WIM or ping device.

Hello, by the way, it’s been a long time...

Wow, I thought you went the way of Snake Pliskin! Good to see you back Debs.

[Debs1964]

Wow, I thought you went the way of Snake Pliskin! Good to see you back Debs.

Thank you, I don't come on here often as I seldom use a laptop, and the site is not good through a phone, but I do have lots of members as Facebook friends. I will try to be more active again, I promise

[FrohnB]

From the Ricoh Tech forum: "UPDATING, the problem here was not the PSU, it was the yellow toner RFID chip. Again."

Symptom was "Stuck on please wait"/ couldn't load firmware/ in this case the fans and stuff did NOT turn on though, so might be different.

Something to look at anyway.

[guitar9199]

From the Ricoh Tech forum: "UPDATING, the problem here was not the PSU, it was the yellow toner RFID chip. Again."

Symptom was "Stuck on please wait"/ couldn't load firmware/ in this case the fans and stuff did NOT turn on though, so might be different.

Something to look at anyway.

It almost sounds to me like the controller is stalling. When in doubt, reseat all the connectors and boards and see if anything changes.

[sandmanmac]

Wow, I thought you went the way of Snake Pliskin! Good to see you back Debs.

haha.......and x2 on that one for sure!

[slimslob]

Wow, I thought you went the way of Snake Pliskin! Good to see you back Debs.

haha.......and x2 on that one for sure!

As she said, she is on Facebook. I see posts daily from both Debs and gwaddle.