Literally just 1 second after pressing execute, it that fails try 2 seconds any longer & you risk doing damage!
However the fuses are peanuts to buy also they come with a new sleeve so this trick isn't worth the risk.
Literally just 1 second after pressing execute, it that fails try 2 seconds any longer & you risk doing damage!
However the fuses are peanuts to buy also they come with a new sleeve so this trick isn't worth the risk.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
i made a jig up with a mini side door switch and an old thermister end connector"think it was a 3pin" and security wire.
It took a bit to trip out code at least on this machine.
I dont think i could fit that other one in my tool bag, so mini one serves my need and stays in my bag in case i see that again..
I also now copy the nvram for all my 02s i service and keep them on my laptop just in case
when the machine tall sc542 544 code fist:5810-01 02 sec:if not reset the machine you must rewrite the BCU NVRAM and install the machin NO.
thank you
Or, use the reset fuse / switch and two wires, and then use SP5-810-02. If you are gettings these service codes, then the fuser sleeve is most likely damaged, thankfully a new sleeve comes with a reset fuse.
You ever need to replace the NVRAM to reset a fuser service code.
Bookmarks