Results 1 to 6 of 6
  1. #1
    copierman 250+ Posts
    Mpc 6502 with sr4090 finisher not stacking correctly


    Join Date
    Aug 2007
    Location
    not specified
    Posts
    364
    Rep Power
    24

    Mpc 6502 with sr4090 finisher not stacking correctly

    Hi all.

    I have an issue whereas when stapled sets are exiting the finisher they are not falling back to to finisher. The staples are catching on the previous set and so stacking is not even. This mainly happens on a double staple. Is there any way to make the mc jog so that the staples don't catch each other. The sponge rollers are ok and I have looked at the pinch bar position.

    Any ideas.

    Networking skills are advantageous but use of a 3m vacuum cleaner is essential

  2. #2
    Just a fellow wanderer 2,500+ Posts Iowatech's Avatar
    Join Date
    Dec 2009
    Location
    Iowa
    Posts
    3,756
    Rep Power
    80

    Re: Mpc 6502 with sr4090 finisher not stacking correctly

    If this happened all of a sudden, you might check to see if the tray angle is correct. I've had a couple of older machines where the metal piece the tray is mounted to got bent and caused something like that.
    You've probably already tried paper from a new ream, as if the paper curls too much I've seen the staples catch on sets with few pages.


  3. #3
    Retired 5,000+ Posts slimslob's Avatar
    Join Date
    May 2013
    Location
    Bakersfield, CA
    Posts
    7,089
    Rep Power
    152

    Re: Mpc 6502 with sr4090 finisher not stacking correctly

    This is a very common event with almost any finisher when stapling sets with of only a few sheets. The thicker the stapled set, the better the staple is clinched.


  4. #4
    worker drone 250+ Posts
    Join Date
    Dec 2009
    Posts
    310
    Rep Power
    23

    Re: Mpc 6502 with sr4090 finisher not stacking correctly

    Agreed...I have never seen stapled sets stack neatly but I believe the engineering mindset is that if they are stapled, neat stacks are not so critical.


  5. #5
    copierman 250+ Posts
    Mpc 6502 with sr4090 finisher not stacking correctly


    Join Date
    Aug 2007
    Location
    not specified
    Posts
    364
    Rep Power
    24

    Re: Mpc 6502 with sr4090 finisher not stacking correctly

    Thanks for the replies guys, the exit tray is at the correct angle. i guess as its only 10 sheets being stapled, the staples are sitting proud and catching, just thought i would ask if there could be anything done.

    Thanks.

    Networking skills are advantageous but use of a 3m vacuum cleaner is essential

  6. #6
    Field Supervisor 500+ Posts
    Join Date
    Mar 2013
    Location
    Meridian, MS
    Posts
    586
    Rep Power
    18

    Re: Mpc 6502 with sr4090 finisher not stacking correctly

    Make sure your foam gathering rollers are not worn out! (nubbins worn down) if they are worn down, it won't kick and stack the stapled sets correctly!




Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here