Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5
  1. #1
    Retired 10,000+ Posts
    MP C4503 Jam code J051 from manual feed table

    slimslob's Avatar
    Join Date
    May 2013
    Location
    Bakersfield, CA
    Posts
    34,126
    Rep Power
    989

    MP C4503 Jam code J051 from manual feed table

    When 8 1/2x11 paper is loaded LEF for copying it is being detected as 11x17. Tried setting default size in user tools, worked briefly then went back to detecting as 11x17. Overriding with the # key at the time of running the job works but the customer does not wish to do that, it is a High School office and most of the faculty need to use it. SP 5803-024 does not change when the sensor arm is depressed, bit 0 stays at 1. I have tried replacing the but no change. I am going to order the cable that goes to it tomorrow. Anyone else with any suggestions?

  2. #2
    Senior Tech 250+ Posts tjvincent's Avatar
    Join Date
    Apr 2008
    Location
    Green Bay, WI
    Posts
    280
    Rep Power
    37

    Re: MP C4503 Jam code J051 from manual feed table

    Yes that's common for the harness to break for the bypass, try to encourage them to leave it open all the time

  3. #3
    Retired 10,000+ Posts
    MP C4503 Jam code J051 from manual feed table

    slimslob's Avatar
    Join Date
    May 2013
    Location
    Bakersfield, CA
    Posts
    34,126
    Rep Power
    989

    Re: MP C4503 Jam code J051 from manual feed table

    Replaced the cable yesterday and that took care of the problem.

  4. #4
    Field Supervisor 500+ Posts Counsel's Avatar
    Join Date
    Aug 2011
    Posts
    530
    Rep Power
    34

    Re: MP C4503 Jam code J051 from manual feed table

    I had to replace the hole door on one of these there is a TSB i think regarding the doors plastic cover being redesigned so that harness isnt pinched. Not fun.

  5. #5
    Retired 10,000+ Posts
    MP C4503 Jam code J051 from manual feed table

    slimslob's Avatar
    Join Date
    May 2013
    Location
    Bakersfield, CA
    Posts
    34,126
    Rep Power
    989

    Re: MP C4503 Jam code J051 from manual feed table

    Quote Originally Posted by Counsel View Post
    I had to replace the hole door on one of these there is a TSB i think regarding the doors plastic cover being redesigned so that harness isnt pinched. Not fun.
    The bulletin that I saw had to do with duplex door and the cover over the bypass feed roller. The machine I was working on was manufactured after the cut in date for the updated parts being installed in production.

  6. #6
    Vitalcopier
    Guest

    Re: MP C4503 Jam code J051 from manual feed table

    Quote Originally Posted by slimslob View Post
    The bulletin that I saw had to do wit duplex door and the cover over the bypass feed roller. The machine I was working on was manufactured after the cut in date for the updated parts being installed in production.
    check the by pass work ot not or clear the pm .

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here