CL7200 pattern every 4.5" printed on back of paper

[steve@grafixsolutions.net]

Replaced Transfer Unit Belt Assembly and now I'm getting a 5/8" wide multi color pattern every 4-1/2" down the back side of the document. The front side of document is fine. Any ideas how to fix this? Thanks.

[TonerMunkeh]

Transfer belt cleaning unit is a bit poorly. Strip it off and lube powder it.

[jhalfhide]

Is that a model where the transfer cleaner comes out with the transfer assy and you're meant to swap it to the new unit (or fit new cleaner with new transfer)?

That's seeming likely if you say it's now only happening after replacing the transfer assy.


Sent from my iPhone using Tapatalk

[mikadonovan]

Transfer belt cleaning unit is a bit poorly. Strip it off and lube powder it.

Is that a model where the transfer cleaner comes out with the transfer assy and you're meant to swap it to the new unit (or fit new cleaner with new transfer)?

That's seeming likely if you say it's now only happening after replacing the transfer assy.

X3. Looks like a problem with the ITB cleaning unit.

[slimslob]

Transfer belt cleaning unit is a bit poorly. Strip it off and lube powder it.

Is that a model where the transfer cleaner comes out with the transfer assy and you're meant to swap it to the new unit (or fit new cleaner with new transfer)?

That's seeming likely if you say it's now only happening after replacing the transfer assy.


Sent from my iPhone using Tapatalk

X3. Looks like a problem with the ITB cleaning unit.

The pattern you are seeing is the ID patches used by the ID sensor assembly that has not been fully cleaned by the ITB cleaning unit. TYhey are on the back because they have been picked up by the PTR and offset on the back.