Ricoh MPC2051/Savin C9120 Vertical transport cover not making door button switch

[copyaction]

Here is the part in question

IMG_3148.jpg

[axyun]

Thank you Copyaction. The cover i had to change was the external cover that presses against that arm that pushes the switch in. So as counsel says that arm is broken of of the internal vertical guide. As i am not that familiar with machine I was unaware of this. I will have to order that guide and cheat the switch until i change it. Frank

[axyun]

Thanks again Copyaction and Counsel. i went back to customer and also to another customer who has an MPC2551. That transport
cover is missing and i would need the spring as well that goes on the left side of cover.

Unfortunately i looked in the parts manual (D104/D1060) and I have not been able to find the cover and spring. i' not crazy about the way the parts manual displays the parts. I like to look in one whole area at a time and see all that is in that area with individual parts numbered and from diagram easy to see each part in position. Frank

[axyun]

Machine I was servicing was a Savin C9120 (ricoh MPC2051) so I looked in the MPC2051 parts catalog(D104/D106 and did not see part but it is in previous parts catalog mpc2050 (D37/D38?D41) and see vertical transport swivel plate #D0392927. Ian ordering but still did not see tension spring for this. Also,i am asuming the mylar sheet is on the guide plate or i will have to order that separately.Frank

[Counsel]

The manual doesnt show the part very well the second feed guide is different then the first one because of that tab, the mylar is already attached to the guide plate. I dont remember there being a spring on it pretty sure it just pops in and flaps there.

[axyun]

Thank you.