Mpc4502 sc532-00

[mrfuser]

Never saw this code before. Any ideas?

[mikadonovan]

Probably one of the fans is not connected. It's in the manual.

[totoro]

532
-01
D Ventilation fan (at the left side of the machine) motor error: front end
-02 D Ventilation fan (at the left side of the machine) motor error: rear end
-03 D
Ventilation fan (at the left side of the machine) motor error: front in the
middle
-04 D
Ventilation fan (at the left side of the machine) motor error: rear in the
middle
The IOB does not receive the lock signal for 100 ms after turning on the
ventilation fan motor in the front end, rear end, front in the middle, or
rear in the middle.
Defective ventilation fan motor in the front end, rear end, front in
the middle, or rear in the middle
Defective IOB
1. Replace the ventilation fan (at the left side of the machine) motor in
the front end, rear end, front in the middle, or rear in the middle.
2. Replace the IOB

[mrfuser]

Thanks but it is a 532-00. Which fan is that?

[totoro]

That was straight out of my service manual. No listing for sc532-00

[mrfuser]

Yep, thanks. I have the manual and ran into the same trouble. Thats why I was hoping someone had seen this before.

Thanks!

K

[mrfuser]

client moved machine, and mashed in the vent cover on the fans behind the finisher on the main unit. Wow, duh! Nice they never admit these things until we catch them!

[guitar9199]

client moved machine, and mashed in the vent cover on the fans behind the finisher on the main unit. Wow, duh! Nice they never admit these things until we catch them!

I know, right??

Had one, a refurbished MP3053 just installed last week. Within an HOUR of delivery, they had already broken part of the right door. Door wouldn't close because they didn't close the duplex and transfer areas, so they just SLAMMED it shut, and snapped off the rear fuser pressure release arm in the door.

Needless to say, the boss wasn't too thrilled.

[sturmtrooper]

client moved machine, and mashed in the vent cover on the fans behind the finisher on the main unit. Wow, duh! Nice they never admit these things until we catch them!

We had a customer where the cleaning crew moved their machine, with the finisher still attached. Well it's a 5002 and since those finishers have non turning casters they bent the finisher several different ways.

Between parts a labor I think the bill was at least $500 for us to unmangle it.

[mrfuser]

Spoke too soon the code came back today even with replacement fans installed !

anyone know why there are four female plugs and only three male plugs for the fan assembly?