Thought I would pass this along but please remember this has not been resolved as of yet. MP C3504 with a SR3130 internal finisher installed with less than 400 copies on it. When running copies the customer experiences a jam in location J113. Upon clearing the jam and trying to finish the copy run you get SC724-38. I had difficulty deciphering the literary confusion in Ricohs documentation but with a little help discovered that the bailing motor was not always cycling with regularity. At first I thought maybe the bailing fingers were binding or hanging up but quickly dismissed it. In all likelihood its either a bad stepper motor or maybe a harness problem. Curious if anyone has seen this or may have further speculation on the issue.
Bookmarks