MPC 3003 Doc Feeder sensor actuator

[Bozz]

Hey i have had this actuator pop out of position from what i think is the exit sensor. Has anyone had to put this back in or had any experience putting it back in?
Without pulling what looks like the whole doc feeder apart. There is only a tiny gap to get it back in and its a nightmare to try and get it into its locator clips and to get the spring in the right spot.

DF is of an MPC 3003.

Thanks for the help.

.DF30032.jpgDF30033.jpgDF30031.jpg

[BEBEDELFUTURO]

Screenshot_2017-07-12-23-22-26.jpgScreenshot_2017-07-12-23-22-26.jpgScreenshot_2017-07-12-23-22-26.jpg

[BEBEDELFUTURO]

40.D6843228
FEELER:REVERSE
I hope I've helped

[Bozz]

Thanks mate, i have the part the problem is getting it back into its position.

[Bozz]

For anyone that has this i got it back in with a spring hook, a fair bit of swearing and i used a small bit of blu tac to get the spring to hold in its correct position while i slowly got the actuator into its spot. I then carefully got the blu tac of releasing the spring to where its meant to go. Pig of a thing to do.