Results 1 to 5 of 5
  1. #1
    Senior Tech 250+ Posts
    Join Date
    Sep 2013
    Location
    Burleson
    Posts
    493
    Rep Power
    27

    MP C3001 Light PCU'S

    MP C3001 where all 4 colors were super light, I would to a forced toner supply to bring them back up to looking good but eventually they would go back to being light. So i switched all 4 PCU's and was good for a while but now they are all super light again. And they all seem to go at the same time. Is there maybe a setting that tells it how long to supply toner for? I know when you are doing a forced toner supply you can change the toner supply time, but is there a way to do that for normal operation? Because i feel like maybe it is just not getting enough toner to it. Toner pumps and hoses seem fine because when i do a forced toner supply i can tell it worked. Any thoughts?

  2. #2
    Service Manager 10,000+ Posts
    MP C3001 Light PCU'S

    Phil B.'s Avatar
    Join Date
    Jul 2016
    Location
    Raleigh NC
    Posts
    22,668
    Rep Power
    658

    Re: MP C3001 Light PCU'S

    did you initialize the new PCUs in service mode?

  3. #3
    Retired 10,000+ Posts
    MP C3001 Light PCU'S

    slimslob's Avatar
    Join Date
    May 2013
    Location
    Bakersfield, CA
    Posts
    34,132
    Rep Power
    989

    Re: MP C3001 Light PCU'S

    Did you clean the ID sensor assembly? Did you run ACC? Did you clean the laser shield glasses? Is the PTR making full contact with the ITB?

  4. #4
    Service Manager 1,000+ Posts
    Join Date
    Oct 2011
    Location
    Hunter Valley, NSW
    Posts
    1,020
    Rep Power
    57

    Re: MP C3001 Light PCU'S

    Did you fit 4 new PCU's, what are the dev counts, do not fiddle with toner settings.

  5. #5
    Senior Tech 250+ Posts
    Join Date
    Sep 2013
    Location
    Burleson
    Posts
    493
    Rep Power
    27

    Re: MP C3001 Light PCU'S

    Quote Originally Posted by slimslob View Post
    Did you clean the ID sensor assembly? Did you run ACC? Did you clean the laser shield glasses? Is the PTR making full contact with the ITB?
    They were not brand new pcu's that i swapped them out with.
    I ran ACC, cleaned the laser shield glass with the cleaning stick in the front cover, cleaned ID sensor assembly...did not check the PTR though, i will check that, clean everything again and let yall know thanks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here