one of my guys has gone to the copier to fit p/r and h/r and thermistor he has fitted all the parts and now the copier says fuser not set .
he has checked all the wires etc but cant get it to clear any one had this problem.
one of my guys has gone to the copier to fit p/r and h/r and thermistor he has fitted all the parts and now the copier says fuser not set .
he has checked all the wires etc but cant get it to clear any one had this problem.
thanks for the reply the only reason for the roller change was for marks on copies and near life parts no SCs etc.
Thanks guys we will re check the connesctors i suspect that is where the problem is
It wasn't my first time working on the model, but the first time I went to take the fuser out of a relatively new machine the connectors were in so tight I damaged them. Had to strip the wire back and re-do the connector was not fun. The second time was on an older machine.
At this point I just use my pliers to grab at an empty wire socket in the connector and work it loose if it doesn't come out easily. When I put it back in I don't shove them in hard like I would most harnesses.
Luckily it's not often the fusers have to be worked with on these models. I miss the ones where the connector was built into the frame though.
Bookmarks