ricoh mpc4000 toner supply problem

[troll0201]

Enter SSP mode, enter system SP, sp-7849 reset

[sturmtrooper]

Same here. It is best to just let the toner run out completely. When the next change happens, the message will go away.

I've had to reduce the Toner Near End setting on a few machines because the customer would change the bottle at the first toner low warning. If I can turn the bottle and feel toner plop to the bottom you left too much in it. Also sometimes the plungers can get stuck open and if there is toner inside you're gonna have a bad time. Had that happen while showing a customer how to change toner on a new install. Magenta all over my feet.