Yes that should have read 75mm from lead edge
as the lead edge hits the fuser the shadow lines up with the itb
Last edited by Elmo; 12-11-2017 at 09:08 AM.
I Used To Live To Fix Things Now i Fix Things To Live
If the fusing unit has an adjustable entrance guide, try adjusting it.
i have had chance to test 3 different machines 2 x mpc4503 1 x mpc5503 all with 280gsm and 250gsm card
all produce the shadow line in the same place some slightly more visible than other
before testing updated all machines to latest firmware, fuser and itb condition good in all machines
iam going to look through the adjustments to see if i can make any difference
but it would seem that this is an issue with the 03 range
anyone had this or have any advise
I Used To Live To Fix Things Now i Fix Things To Live
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.
Thanks Tonermunkeh
I Used To Live To Fix Things Now i Fix Things To Live
No worries - but as mentioned in the file, it isn't a total fix and will cause issues.
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.
Bookmarks