Hi Folks,
i have a brand new MPC 2504ex who comes with a SC 540-00 but only in the high Quality mod,means the 4.Calibration Chart,or when using
thick 2-3.
When the maschine runs in normal mode/speed it works great.
Any Ideas ?
Cheers
Roger
Hi Folks,
i have a brand new MPC 2504ex who comes with a SC 540-00 but only in the high Quality mod,means the 4.Calibration Chart,or when using
thick 2-3.
When the maschine runs in normal mode/speed it works great.
Any Ideas ?
Cheers
Roger
Any fusing issue first check the power to the machine. Is it a steady 115-120? The thick mode is going to need a little more juice and could be kicking out the code. We have a few customers right now popping these codes whenever someone turns on their space heater.
Hello,
the Power seems to be OK.
We got 220 V hier in CH.
Question: Ist there a Possability to adjust the Torque of the Fusing Motor in the SP Mode ?
It Looks that the Motor losses its Power during the slow passage of the Paper.
Until now,i changed: Fusing Unit , IOB Transport , IOB Imaging , PCB Image Proc Unit , BCU
I also updated the Firmware.
Now i am out of any Ideas ...................
If its a brand new machine log a ticket with Ricoh under warranty don't waste your time & money!
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Good morning,
after spending hours of hours trying to fix this Sc540-00 i can inform you,that the Drive Unit/Paper Exit Unit ( D2411357 ) or maybe one
of the Motors on it was the Problem.
Greetings
Roger
1.jpg
Hi Folks,
sadly i have to inform you that our Problem Maschine comes again with a SC 540-00 after installation of a
SR 3180 Finisher.........................
When i fixt the Maschine if done several Hundrets of Copy/Prints in the highest Solution without any Problem.
Now with the Finisher,this f.....g Maschine makes me cracy.
I think we put this f..k in the Press.
Greetings
Roger
Bookmarks