Reset fuser sc code on pre 5-810

[andy227]

Can anyone remember the procedure for reseting fuser sc's on older b/w machines that didn't have the sp 5-810 reset code. Was on a Aficio 1515 today and I couldn't remember how to reset an sc 542 after doing a fuser repair. There is a sc/jam reset, but that does not seem to reset the fuser. I seem to remember holding down two buttons while switching on the machine, or something along those lines. Thanks.

[sandmanmac]

Enter SP 5-810 (SC Code) and select “1”. Then simultaneously press the “Original Type” key and the “OK” or “Enter” key.

[andy227]

There is no sp 5-810. It goes from 807 then 811. It has to be another way.

[sandmanmac]

There is no sp 5-810. It goes from 807 then 811. It has to be another way.

Ooops. My Bad. That's for the 1013.
For the 1515, like most others, you just enter SP mode and power off/on
If it's not resetting, then you must have another problem.
From the manual:
Aficio 1515.pdf

[slimslob]

Of course you must first repair what ever caused the service code.
One other little thing, if it codes while you are in service mode, you must exit service mode, cycle power, wait for the code to come back up and then enter service mode. Power off while still in service mode.

[Polarbear]

Ooops. My Bad. That's for the 1013.
For the 1515, like most others, you just enter SP mode and power off/on
If it's not resetting, then you must have another problem.
From the manual:
Aficio 1515.pdf

+1