I can't believe how often I'll read a thread here about an issue that I've not necessarily seen myself, and then have the same experience myself almost immediately afterwards. It's happened many times!
But in this case, I just picked up a couple of very low mileage SP5200s machines that were previously in banks, and they had all sorts of secure settings setup. After getting them
unlocked, I still couldn't get them to print.
After following all of my own advice provided earlier in this thread still no go.
A memory clear was what ended up resolving my issue. While I can't say exactly which one resolved the issue, these are the ones I cleared:
SCS, MCS, Printer, NCS. Rebooted, then then re-input my network settings, and BANG! All good.
So if the previous suggestions don't resolve it, then this might help
Bookmarks