MP6002 sc540-03

[MIKON]

Hope this helps.
I would try the new part numbers.

[slimslob]

I don't know if this is applicable or not but I have bad 1060s in the past that at most a week after replacing the web would indicate that the web needed to be replaced. I would go there to replace the web only to find it was still good. I tried replacing the web end sensor to no avail. Then I noticed that the harness going to the web passed over some screw heads at the front of the fusing unit frame. After I rerouted the harness the problem never recurred.

[Paper_Jam]

You need to reset web

001 Fusing Web Used Area Display/Setting
Displays the percentage of the web consumption in 1% steps (0% ~ 100%). This
setting must be reset to zero after the web is replaced.
[0~120/1 %]
002 Fusing Web Motor Operation Interval
Adjusts the interval of copy operation time (seconds) after which the web motor is
driven.
[5~50/1 s]
003 Fusing Web Motor Operation Time
Adjusts the length of time that the web motor is driven.
[1~40/0.1 s]
004 Web Near End Value
Adjusts the timing of the web near end alert by changing the amount of web that
has been used before the alert is triggered.
[0~100/1 %]
005 Web Roll Coefficient
Determines the coefficient of the web take-up time from cleaning toner from the
roller while taking