Guys, have you encountered this kind of problem? Replacing the fusing unit will solve the problem but it cost much. My question now is, what particular part in the fusing unit causes the error?
Guys, have you encountered this kind of problem? Replacing the fusing unit will solve the problem but it cost much. My question now is, what particular part in the fusing unit causes the error?
Last edited by sharpmind; 06-20-2018 at 08:37 PM.
From the manual:
Remedy
• Replace the NC sensor • Reset the connector • Replace the connector • Replace the fusing unit
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
SC551-03 A Edge NC Sensor Short-circuit AD value: 0-13 (FB voltage: 0.000V-0.041V) (*3) is detected for (t14) seconds continuously.
Detection period: 100 ms, detection frequency: 10 times or more.
- NC sensor short-circuit
- Connector disconnected
- Replace the NC sensor
- Reset the connector
- Replace the connector
- Replace the fusing unit
Bookmarks