MPC3002 SC672-001

[copier tech]

Hello all,

I'm faced with an SC672 that wont clear, happens as soon as machine powers on after about 5 seconds.

Disconnected the fax & HDD, machine wont accept a firmware.

I have reseated all controller connections, still same.

Any other suggestions?

Dont really want to order a controller on this old box.

[guitar9199]

Hello all,

I'm faced with an SC672 that wont clear, happens as soon as machine powers on after about 5 seconds.

Disconnected the fax & HDD, machine wont accept a firmware.

I have reseated all controller connections, still same.

Any other suggestions?

Dont really want to order a controller on this old box.

Check the setting of SP5-875-001. If the setting is set to "1 (OFF)",
change it to "0 (ON)"

[slimslob]

Check the connection between the control panel and the controller.

[copier tech]

Cant get in SP mode, removed & reseated all connections inc panel USB cable etc.

Hopefully customer will upgrade...........................

[MIGUELMARCHENA]

Hello


what done?


1) I remove the hard drive and the memory
I enter a system


I copy the ram


I erase errors 7807


turn off
firmware charge


turn off


I connect disco and I put memories


prendo and full


sometimes had to erase memory 5801 doing everything else


You always help me .. I would like you to be able to repay this time


regards

[slimslob]

Cant get in SP mode, removed & reseated all connections inc panel USB cable etc.

Hopefully customer will upgrade...........................

If it comes back intermittently, reseat the other end of the USB.

[copier tech]

If it comes back intermittently, reseat the other end of the USB.

Unfortunately its a permanent error, powered off/on multiple times.

HDD & fax removed same error.

If customer doesnt upgrade will return to base to work on.

Appreciate the advice as always. 🙂

[jonhiker]

You may need to replace the controller and the IPU as a set.

[COPIERMAN]

i had one that be find then throw code sometimes right away or day or two later. Turns out was the operation panel was bad. other things can be the usb cable that runs from board in back to the operation panel. my was the op assy.

[JDYAL]

I've had this code on two different machines a wide format MPCW2200 and a MPC3002. The Mpcw2200 was the controller board and the mpc3002 was the op panel. Not a big fan sc672-001 it will definitely give you nightmares.