Thanks:
0
Dislikes:
0
-
MPC4502 J060 when running transparencies
Hi all,
I have a machine giving an occasional jam code 60 only when transparencies are run through the bypass. The user's driver is set up to deliver the proper paper type settings. The transparency will come 1-2 inches out of the bridge unit tray and stop there.
I don't ever get to fight with these types of paper, so any tips would be appreciated
-
Re: MPC4502 J060 when running transparencies
Bumping this thread because I have the same issue on the same machine. Only i cannot run any transparencies, gives J060 every time, if it is a print job, it tries to come out of the bridge exit tray and stops. If it is a copy, it stops on the way to the finisher, same jam code J060.
The transparency has a white strip which we are running from the lead edge.
-
Re: MPC4502 J060 when running transparencies
If you are suspecting it is a hardware issue, how bout trying to isolate it?
Disconnect bridge and finisher then recreate the problem.
If it works fine, check your bridge and finisher.
B/R
-
Re: MPC4502 J060 when running transparencies
I actually got it running by changing the orientation to portrait, so the white strip ran along the top of the page. Time will tell if this is a permanent solution, since SEF seemed to be the fix last time I worked on it.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks