Team
I need thermopile unit for MPC 2004.
Machine is giving error code 442-02
Has anybody replaced it? Is it available somewhere, here we are getting only complete fuser assembly
Regards & thanks in advance.
Team
I need thermopile unit for MPC 2004.
Machine is giving error code 442-02
Has anybody replaced it? Is it available somewhere, here we are getting only complete fuser assembly
Regards & thanks in advance.
442 is not fuser related...ITB related
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC442-00
D
ITB Lift Error
Even though the ITB contact and release motor (also Toner supply motor
(M)) rotates, the ITB contact and release sensor failed to detect the
specified sensor feeler status within specified time.
Contact/separation operation: If not detected in 2000msec
Home position operation: If not detected in 5000msec
Signal detection sampling period: 10msec
Image transfer unit not set/faulty setting
Sensor dirt
Sensor defective
Motor defective
Unit load large
1. Reset the Image transfer unit properly.
2.
Clean the ITB contact and release sensor
3. Check the harness (disconnected, loose connectors)
4. Replace the ITB contact and release sensor
5. Replace the image transfer unit
6. R
[QUOTE=fshead;716988]442 is not fuser related...ITB related
Sir
Thank you for your quick response & extremely sorry for my mistake.
It is not SC 442-02 it is 542-02 - "Thermopile (Center) does not reload"
Sorry again & looking forward for some suggestions / inputs from all
Regards & Thanks again
On this model, the thermopile is located on the frame behind the fusing unit. When you pull out the fuser, you will see them
Sometimes the thermopile just needs to be cleaned of debris, if that doesn't work replace it and reset the the code in service mode.
It's a rare day that a thermopile goes bad. Probably a problem with the heat sleeve or thermistors.
Bookmarks