Hi,Can anyone help with this,MPC 3003 K drum not fully inserting into machine? the other devs no problem but feeling some resistance on the K drum, and does not appear to have fully engaged?
Hi,Can anyone help with this,MPC 3003 K drum not fully inserting into machine? the other devs no problem but feeling some resistance on the K drum, and does not appear to have fully engaged?
there is a grey plug in the front that needs to come out on this model. i believe its on the left front side. also may need to turn the drum alittle to get it to slide in.
The grey plug only needs to come out for 55/6503, make sure you have re-assembled the PCDU correctly.
Probably should have explained better, this machine has been put on a second floor with awkward access so had document feeder, cassette pedestal, fuser and dev units removed to aid access by lightening the machine and making it a little smaller, it was then carefully carried to its new location, then everything re-installed with the final job being to reinstall the pcdu units, no problem with yellow/magenta/cyan all seemed to fully engage ,however the K drum seems to be about 5mm short of going in, obviously don't want to force anything ,i have checked the unit and can't see anything wrong with it?
This must be something obvious that i'm missing its definatly the K drum, doesn't appear to have a shaft going through it, just the 3 gears i can see.
Yes i did release the ITB contact lever in order to remove the black PCDU, but the ITB itself was left in the machine, i have opened the right cover of the machine and opened the paper transfer unit and can see that as the black PCDU approaches the rear of the machine it does not fully engage with the rear drive gears, its almost like one of the 3 dev unit gears is in the wrong position to line up
Bookmarks