Is the process control ok? You said you have replaced most of the parts, so I'm wondering if you have executed the process control settings. How bout your firmwares? Printer driver? Toner? Would you mind sharing the SP data of your device?
Is the process control ok? You said you have replaced most of the parts, so I'm wondering if you have executed the process control settings. How bout your firmwares? Printer driver? Toner? Would you mind sharing the SP data of your device?
Aye! Cut the crap
SKMBT_C35319021811540.pdf
The last thing I have left to change is a polygonal motor and the laser diode
Last edited by pakobernal; 02-20-2019 at 08:40 AM.
I would be upset with this issue, too. It's so dark you can't even see her boobs clearly. Seriously overtoned. After seeing what you have already replaced, I'm wondering if you have a bad ID sensor. Maybe you should clean the id sensor, detone the machine to an acceptable CQ level and then set developer . If detoneing does not give you a halfway decent print, it may be an image processing issue. Drum ground?IPU? I just thought of something, make sure the filters are clean. I used to have a bunch of these machines, and image quality issues would appear if the filters were clogged up.
NEVER ASSUME ANYTHING
Bookmarks