Did you reset high heat sp after 5810, 002 .I think if it fails then you should check pluggable fuse on fuser, as said previously, comes with new sleeve.
Did you reset high heat sp after 5810, 002 .I think if it fails then you should check pluggable fuse on fuser, as said previously, comes with new sleeve.
i had something like that with a mpc3502 that would nt reset and ended up making a fuse reset jig wth a small door switch and the end connector to a thermister and some wire.
for some reason machine refused to blow that pico fuse and reset.
So after 15 attempts wth pressing the jig and timing the fuser reset it came back.
I started copying nvrams off all the machines i put out afterwards as i figure if it ever happens again i can
just revive the nvram to original working condition.
Can you go to the end of the 3s, and on "manual set new unit, set fuser to 1?
Fyi, nvram guys. Thanks for the reply's
Bookmarks