Thanks:
0
Dislikes:
0
-
MP6001 with SR4030 finishe and punch, "empty punch container" message does not clear.
The empty punch bucket message will not clear. I have cleaned the sensor and re-seated the connectors on the punch unit board and
the finisher control board. I don't have my infra red sensor to check for the light.
It has worked fine for almost a year
Also I get a message about "cannot punch this size or way" I will have a closer look tomorrow.
Has anyone else had any experience with the punch?
Thanks
DR
-
Re: MP6001 with SR4030 finishe and punch, "empty punch container" message does not cl
See if you can check sensor in input mode.
-
Re: MP6001 with SR4030 finishe and punch, "empty punch container" message does not cl
I had to replace the sensor on one.
-
Re: MP6001 with SR4030 finishe and punch, "empty punch container" message does not cl
I probably should've just stayed a little longer, but I was having trouble finding it in the book.
and now I have located the information in the manual for the main frame.
I think I'll have a look for the service manual for the punch. It is type 3260 B702.
Thanks
DR
-
Re: MP6001 with SR4030 finishe and punch, "empty punch container" message does not cl
Had a tech support call last month on the same prob. It was the HP sensor of the punch unit. It turned out, the seat where the sensor is installed got deformed.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks