Originally Posted by
Brianneoe
From the 3606 manual, did not see it on my 2401 manual but its probably the same solution..
406 D ID Sensor Pattern Edge Detection Error
The ID sensor pattern check could not detect the correct voltage on the ID
sensor pattern (below 2.5V) within 0.6 sec.
�� ID sensor dirty
�� ID sensor harness loose, damaged, defective
�� ID sensor connector defective
�� ID sensor defective
�� MCU defective
�� CGB power pack defective
Did you replace the drum first and then had this problem? If the allen screws are loose the drum drive could be slipping causing this problem.
Good luck
Bookmarks