mp6001 hung up

[vargue]

my customer call me that sc555 generatend and detect that lamp tungesten wire cut. i get anew lamp 550w 230v and every thing good. after two days customer called me that machine hungs up for 10 seconds and throw sc672. i close switch on/ ff . and it's working again . i replace hdd clean ram .it's not appeared after machine warm up. it's may be not appear in all day.it's throw intermittentley. did any one encounter that befor

[sandmanmac]

Just about the most annoying SC code with the most causes on nearly every model.
Search the site. It's discussed on Many many models.
Here's one thread that might help: MP7500 SC672

Good Luck

SC 672	controller start up error - reseat connectors on controller
SC 672	controller start up error - remove fax card and reboot
SC 672	controller start up error - replace Controller PCB.
SC 672	controller start up error - check jumper on MBU battery is in correction position per FSM
SC 672	controller start up error - Replace Java Option.
SC 672	controller start up error - reseat memory dimms or replace
SC 672	controller start up error - Update System firmware to v1.20J or higher
SC 672	controller start up error - Reseated op panel connectors
SC 672	Controller start up error - IPU defective

[MIKON]

Clean the contacts on the dimm's

[Dan G]

update all firmware including JAVA - JAVA update is very important fort this SC code believe it or not

[vargue]

did some one had firmware? 🤔