Thanks: 
Likes: i replaced the ITB belt and the machine is still going light to dark. the fuser has less than 30 k on it
the black pcu and developer around 35k.
ty in advance for any help
Dislikes: 0
i replaced the ITB belt and the machine is still going light to dark. the fuser has less than 30 k on it
the black pcu and developer around 35k.
ty in advance for any help
Originally Posted by heath03
did you run adjusts/inits on items replaced?
OEM parts/supplies?
did you re-check all contacts?
post the BC pages for the bias/volts settings...
Why did you replace the transfer unit?
Does the issue only happen in mono?
run the colour test prints in service mode this will help you narrow down the cause.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
You need to give more info.
total b/w and color meters on machine,using OEM/AFTERMARKET TONERS?
Why did you change ITB belt?torn worn? and didnt change the cleaning unit??????
did you try sing color copies?
is the copies from 1 tray or 81/by 11 reduction..
hows the fuser look?
So you did not like the answers we gave you on your previous thread and thought we would answer a new thread differently? If one of my junior techs had ignored advice and replace an expensive assembly, he would be looking for a new job.
What type of paper you are using?
i think it's Fusing problem.
i agree fusers can cause like uneven,lite CQ too and that is why i asked him to expand his post
Clean the ID sensors/optics and then run ACC.
NEVER ASSUME ANYTHING
ITC belt replaced bc it had 460,000 on it. the fusing unit has 751 impressions on it
PCU has 250392 dev the same. the PTR unit has 409571 on it, i just don't think that would do that but ill replace it.
the toner is not OEM toner
a new ITB unit and you did not think a new cleaning unit would be in order........at 1/2mil
Reply With Quote
Bookmarks