Machine copies fine then as soon as we print it jams j003
printing letter size
odd eh?
Machine copies fine then as soon as we print it jams j003
printing letter size
odd eh?
Does it print and copy out of the same tray?
J003 is no paper pickup from tray one. I would replace feed rollers and see what happened after that.
+1 on Coptech statement. Usually the Sep. Roller, but sometimes the end fence is back too far, or paper is curled up under the stack. A couple things to check anyway.
Replaced Trey 1 feed assembly and works fine now
Spoke Too soon client called back this morning with same jam!
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
cant remember if that use a clutch to engage feed tire if so replace it. Other is lifting of paper if something cause it to bind a little bit and does put enough pressure can cause not to feed properly. maybe to rule out cassette tray swapping to make sure it not causing problem.
Swap the feeding feetwho works well, puts it in the box that bothers, so you know if it is for rubbers, sensors, seals etcor if there are other things like sizes etc.
must be a dirty/defective clutch from behind.
Aye! Cut the crap
Bookmarks