And if you scan to a PC?
And if you scan to a PC?
Whatever
Remember Ricoh mp2550?
Same issue after about 60K: kopie bad, print ok.
Only solution was to replace the PCU.
I think those Japs knows what they are doing to sell more PCDU's.
No?
Read the OP, PCDU was changed.
If the copies are still bad you want to open the laser and clean the mirrors inside. Then run acc providing you have also cleaned the mirrors in the scanner
Sent from my SM-G930F using Tapatalk
Just an update to this:
Went back to the machine for more testing and it's sorted itself out.
Copy quality is good now.
The only thing I did was run ACC for copy but they had previously copied jobs laying around the room and they looked fine as well.
Just a machine messing with my head...as usual
Just so I know, when you replaced them you set new unit in Process part of Service mode? then turned machine off and on, then did the rest etc
For me the 03 colors are not as dark/dense as the 02s.
I doubt the drums go but can see the developer breaking down and causing CQ issues..
Bookmarks