Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
I have noticed over the years the copies are never quite as good as the prints. I explain to my customers that the extra layer of hardware and processing for copies is the cause, like comparing a second generation image to the first. Still good, but not quite the same. However, looking at the images you uploaded, the copies look like they could be improved upon (unless the upload scan to CTN was kind of f#%ked up).
Last edited by mikadonovan; 06-27-2019 at 03:53 PM.
NEVER ASSUME ANYTHING
You're on the right track with something in the scanner section. Mirrors "fogged"? I have noticed this sometimes after cleaning optics, and have to re-clean.
Also, have you tried cleaning or replacing the "Lens Assembly" over to the right? About the only other part to try since you said you did the LED lamp, and SIO board.
scanner, for sure. optics?
Last edited by eddy out; 07-03-2019 at 03:39 AM.
I hope I'm not trying to teach my granny to suck eggs but you did remember to reset the ITB release lever so the belt is in full contact with the drum?
I got caught the other week.
At least 50% of IT is a solution looking for a problem.
Bookmarks