Dear all,
May i ask after i do a memory clear (all), the calibrate for print colour is very poor. May i know how to slove it.
Many thanks
Dear all,
May i ask after i do a memory clear (all), the calibrate for print colour is very poor. May i know how to slove it.
Many thanks
Hi
After clear all you need to enter values from non-default page. Next step is initialize TD sensors, force line adj., toner density adj.
all memory clear is last thing you what to do. also if you don't have information sheet from when it was first setup then every setting has to be readjusted. You didn't say how many copies on the color units. Could had been they are wore out and need to be replace. Good luck you might have cause yourself more headache.
download.jpg
That is all........
Aye! Cut the crap
i have sent you a PM
Run force line position C then A SP2111
If you really need to do an all clear be sure to back up the nvram first.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Bookmarks