Hi
I just picked up a few mp 6002 and notice both have lite toner density.
I know there is a bulletin regarding this,and will read it.
I want to check my FW and get machine cleaned up and ready.
thanks
Hi
I just picked up a few mp 6002 and notice both have lite toner density.
I know there is a bulletin regarding this,and will read it.
I want to check my FW and get machine cleaned up and ready.
thanks
Firmware history attached.
MP6002 FH.pdf
thanks..
One problem these type 50-80 ppm models have that results in light toner density is a dirty ID sensor. If the problem is recurrent, replace the cleaning brush and cleaning entrance seal to reduce toner falling onto the ID sensor.
thanks
I still have a lot of mp 5500 to mp6001 units in the field always pull the sensor and ck/clean the mylar,drum blade and cleaning brush with CQ calls.
I checked the pm history and it seems both had developer changed within 40k.
I have yet to pull out drum nor developer unit.
I have these lined up for later in the week.
Bookmarks