Hi to all,
After 100k copy become blurred copy but after i force toner the copy fine in 5k only..I already cleaned the drum unit assy.
Any idea on this...thanks and happy new year to all..
Hi to all,
After 100k copy become blurred copy but after i force toner the copy fine in 5k only..I already cleaned the drum unit assy.
Any idea on this...thanks and happy new year to all..
Sounds like the typical toner problems with these machines - definately change the developer, sometimes the entire developer assy has to be replaced before it will run (sort of) correctly.
73 DE W5SSJ
Hot off the press
There is now a new dev unit available that they say helps to prevent the toner sticking to the mag roller.
D009 2301
Also cleaned all the optic unit.PM for the Developer is 320k.
Did you tried to clean the Lazer Unit? if yes change the new developer and performed the initialization of new developer.
It's not unusual to have to replace developer on this model well before the PM limit. There is an issue with this model with toner sticking to the mag roller and throwing off the settings. Ricoh has put out several bulletins on this issue. Also check your drum ground. Anything higher than 5 ohms and you should replace that as well.
Start with developer though, also make sure your customer is using the correct toner.
Never seen one of these make it to PM on the developer yet. The new assembly helps, but it's not a fix. 100k seems to be the limit before it barfs, but I've been told some accounts only got 15k...
73 DE W5SSJ
Bookmarks