Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 33
Update
It's been almost 4 weeks and both machines are still running great.
I guess the scanner unit just wanted to get out of the office for a little while. I am baffled, but there's nothing to troubleshoot at this point. i am happy that they are both working. (Knock on wood)
I want to thank everyone for their input.
-
Senior Tech
100+ Posts
- Rep Power
- 33
-
This SC code related to few possible causes:
- I/F harness of the polygonal mirror motor disconnected or defective (check all connectors for a poor harness connection also if they were connected properly). Sometimes even a new motor could be defective.
- Polygonal mirror motor or polygonal mirror motor driver defective (check the driver).
- Polygonal mirror motor drive pulse is not output incorrectly (could be a defective motor even a brand new).
- GABIC cannot monitor XSCRDY signal.
- Polygon mirror motor control board
- LDB (laser detection board) is defective
- SC337 issue ~ modified BICU board serial # starts with letters OZ or the #1, repaired board has blue mark on the serial # label
Good luck!
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks