I put my money on the development drive gears. Looks like the toner is not properly fed in the developement unit. I would replace the 2 gears and add new developer.
Thanks: 0
Likes: 0
Dislikes: 0
I put my money on the development drive gears. Looks like the toner is not properly fed in the developement unit. I would replace the 2 gears and add new developer.
In this case I'd seconded Eric's statementOriginally Posted by ash_572
It can be a simple thing, did you check if the front door slide actuator that works with the microswitch is not stuck, this switch tells the machine that the front door has been open, when changing the toner bottle.
We can all Win, but at the end we all loose. Save the greyhound
If the dev is full of toner, probably the mixers arent turning. They are driven by the 2 gears on the mag roll. The developer tears those gears up. If the gears in the dev section (3) are torn up dont replace them, replace the whole section.
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
its got nothing to do with the door switches thts for sure. i replaced the dev section unit second hand. problem solved. lets hope tht one doesnt come back in.
If you didnt replace the mag roll gears,it will be back. Believe me when I tell you.
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
the dev section tht i replaced with had gears on them anyway. its not like it had the same gear and mag roller in it.
I know, it has three gears, what I'm saying is there are 2 gears on the mag roll above the dv unit that drives the dev unit. These 2 gears are the problem.
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
4 me it better change whole unit of pcu unit.you save your time and less headache.this same as the Af1022/27.the padler roller breaks.
Double check the drive gears in the dev tank had a few these go
Posting Permissions
Reply With Quote
Bookmarks