lastweekk i put developer type 19 because the prints were too pale. tht sorted the problem out. this week customer says its not loading toner now. will this be sumfin to do with the dev i replaced or isit the toner bottle? any ideas?
lastweekk i put developer type 19 because the prints were too pale. tht sorted the problem out. this week customer says its not loading toner now. will this be sumfin to do with the dev i replaced or isit the toner bottle? any ideas?
try to run force toner, then check the toner entrance of DV unit to see any new toner trace were added there.
Also check that the mag roller drive gears aren't minced, favourite on these.
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.
check if the toner motor/hopper/dev drive is working correctly
how can u check if the drives and motors are working correctly? output?
Hey Ash. I bet it's just the tonner hopper. It'll get to where it won't feed the toner thru. Mylars get worn out. Just replace it, tone it up and I bet it works.
Ginger
the hopper is actually droppin toner into the pcu. cuz the hole is full of toner.
If the hole's full of toner that means either the PCU isn't being driven correctly, the TD sensor is faulty or the PCU shutter is faulty. Pinch a PCU from another machine and see if it works.
It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.
Bookmarks