I was only speaking of the Savin 9090. That's where the SR4050 and SR5010 came in. Again, my combo had a timing issue that was resolved by the beta firmware only because the newer series machines do not print at their rated speeds from beginning to end. They start out slower and speed up to a speed faster than their rated speed. But throughout the job, they run their avg rated speed.
The problem, again only with my issue, was the fact that the third party product (the StreamPunch) ran at 90 pages a minute when connected to the 9090. So, at the beginning of the job, the 9090 might start out at 80 ppm and the GBC would be running at 90. The GBC would try to compensate for the timing differences, but it couldn't. Then jam. All the firmware did was allow the 9090 to run at 90ppm from beginning to end.
Bookmarks