Purchased a reconditioned laser assembly unit from Hytec and installed it. Machine works fine and is delivered to customer.
Thanks for all you help.
try this
perform SP 2-109 to adjust the laser beam pitch
SP2-110 Test Mode Dpi (0: 400 dpi, 8: 600 dpi)
SP2-109-1: LD Beam Pitch Adjustment . 400 dpi
SP2-109-2: LD Beam Pitch Adjustment . 600 dpi
SP2-109-3: LD Initial Setting . 400 dpi
SP2-109-4: LD Initial Setting . 600 dpi
1. Set SP2-110 to 0 (0: 400 dpi, 8: 600 dpi)
2. Do SP 2-109-8.
3. For SP2-109-1 input 144.
NOTE: The entry .144. is only a starting reference value that will allow the
machine to operate. It is only a starting point for adjustment.
4. Perform SP2-109-3.
Open the laser unit and clean the small rectangular glass next to the laser diode. It's the first thing the laser goes through. I have seen a lot of them that is dirty. BEFORE YOU REMOVE THAT GLASS, mark the top part and return it in the original orientation, else SC-322 will appear.
Bookmarks