Aficio 200 Misfeed B

[mathfolarin@yahoo.co.uk]

I have this Aficio 200 two in number, both of them is showing Costant Misfeed, B.

I have checked every where, no paper any where.

Again I have use service code to check all sensors, they are all okay except fuser exit sensor which I can not identify, that fuser exit sensor shows 1 while others show 0.

Please I will appreciate early assistance.

Mathew

[mathfolarin@yahoo.co.uk]

Cant anyone respond to this thread, I need to fix tese machines urgently.
Pleeeaase

[dwparker.wa]

The fuser exit sensor is to the LEFT of the triangular knob to remove jams in area C. Lower the paper guide in the cavity on the left, reach in to try to grab the lead edge of the paper and use the knob to try to remove the jam.You may have several sheets folded in the fuser unit, so be prepared for a bit of an adventure removing the fuser to get at the jams.
After you get all of the jams out, check the 2 rollers on the shaft after the fuser unit. They are held in place by a single plastic finger that sits in a groove in the shaft. If the finger is damaged the rllers will move along the shaft causing creasing, folding and jamming.
I hope this helps you some.
Parker