I have an sr840 on a 2105 which has jam 25 on the second stapled set of a job run, first set exits ok and then jams on the second set with Jam25 shown. I seem to remember something about this but cannot remember what causes it, any ideas ?
I have an sr840 on a 2105 which has jam 25 on the second stapled set of a job run, first set exits ok and then jams on the second set with Jam25 shown. I seem to remember something about this but cannot remember what causes it, any ideas ?
Found these solutions on Ricoh global knowledgebase for jam location SP 7-504-25
BCU defective
finisher main control board
replace punch unit
Pre stack gate solenoid
replace fusing/duplex motor
finisher entrance sensor
Don't take that toner with me!
Thanks,
looks like it was a slow soleniod allowing the first sheet of the second set to be misfed.
Bookmarks