Originally Posted by
halac0ax
I got a real problem machine with this C2525. It keeps popping a SC555 code about every week. I can reset it and its fine until it decides that it needs some attention. I've replaced the whole Fuser and Power supply but it keeps coming back. I'm now asking for help with it, so if you have any other ideas I'm open to them.
I had the same problem on Friday with an MP 9001. There is a TSB that might apply. rfg040429,
SYMPTOM:
A SC542 or SC555 occurs.
CAUSES:
•
Temperature misdetection has occurred by the thermistors.
•
When using paper with a high paper dust content, the amount of toner that sticks to the surface of
the fusing roller increases. This toner and paper dust mix then sticks to the temperature-detecting
elements of the thermistors. As a result, the thermistors are unable to detect the temperature of the
fusing roller correctly.
SOLUTIONS:
If the symptoms occur:
1. Clean or replace the Fusing Roller.
NOTE:
If the fusing roller is dirty, the toner and paper dust tends to stick to the thermistor more easily.
If the SC codes continue:
2. Replace the Middle and Rear Thermistor Brackets.
NOTE:
This will secure the thermistors in the correct position, which ensures that they can detect the
roller temperature correctly.
The distances [A] are different between
the new and old style brackets.
Old P/Ns - B1404196/7: 14.8 mm
New P/Ns - D0624196/7: 15.3 mm
PART NUMBERS ARE FOR THE MP 9001.
From the c2525 service manual.
SM 4-51 B230/B237
Trouble
shooting
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Pressure roller lamp consecutive full power 2
When the fusing unit is not running in the ready condition, the pressure
roller-fusing lamp keeps ON full power for 8 seconds or more.
Broken pressure roller fusing lamp
Related SC code: SC 545
555 A
1. Replace the pressure roller fusing lamp.
2. Replace the PSU.
AND
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Heating roller fusing lamp consecutive full power 1
When the fusing unit is not running in the ready condition, the heating
roller fusing lamp keeps on full power for 8 seconds.
Broken heating roller thermistor
Related SC code: SC 555
545 A
1. Replace the heating roller thermistor.
Seems very similar to what I had by your description.
Let us know if it works or if you need more help.
Bookmarks