Very intermittant but always the same code. Problem since install, now has about 50K on it now. Last time I was there I replaced both heat lamps, u-fuser roll and bushings, both thermistors (0131 and 0132) brackets, stats. Update the firmware to Eng P Sys D ADF H. Installed a line filer.
Previously the BCU was replaced.
I havent made any temp adjustment yet because it isnt overheating, in fact it seems just the opposite.
This time it lasted 2 weeks.
It is on a dedicated power line but of course, I dont know if there are any sags.
Looks like they took the Phase/on-off adjustment off of this model (1104) or I would try that.
Anything?
Bookmarks