Savin 2070dp Scanner Slamming

[mrfuser]

Okay, scanner continues to slam back on this one. We checked all mirrors, pullys, etc. Replaced MCU board, still errors out and slams. Any ideas?

Thanks!

Kelly

kelly@pcbmonline.com

[Fearless V K]

Have you checked the pulley set screws? These break or back out.

[teebee1234]

Confirm, there is a tech bulletin (A292/293 - 034)


SUBJECT: SCANNER SLAMMING & SC124
SYMPTOM:
Scanner slamming occurs and/or service code 124’s.
CAUSES:
1. Faulty MCU Board.
2. Scanner pulley screws are fractured and/or scanner belt tension is loose.

[msaeger]

I had one that replacing the NVRAM chip on fixed it. This one was really weird because every time the counter sheet was printed out the next copy would be a slam. Doing the NVRAM clear didn't fix it either.

[Vulkor]

I had one that replacing the NVRAM chip on fixed it. This one was really weird because every time the counter sheet was printed out the next copy would be a slam. Doing the NVRAM clear didn't fix it either.

That is an odd one, but as someone mentioned above I go with the Screw Seen this happen on the old Savin 2050 (I think)