I'm getting an sc 742. When you turn the copier on you get a remove jam for r2 & 3 then 742. Replaced the motor, lubed the stapler bar adjusted tension on the belt, and replaced the hp sensor but still getting the fault. Any other suggestion?
I'm getting an sc 742. When you turn the copier on you get a remove jam for r2 & 3 then 742. Replaced the motor, lubed the stapler bar adjusted tension on the belt, and replaced the hp sensor but still getting the fault. Any other suggestion?
What model of finisher attached to what mfp? Can I assume you mean you replaced the shift motor and shift roller HP sensor? Could also be some type of mechanical load binding the drive or bad harness connection. The only time I have had this error was a defective shift motor.
Last edited by teebee1234; 05-18-2010 at 03:02 AM.
And the question remains the same.
What model of finisher attached to what mfp? Can I assume you mean you replaced the shift motor and shift roller HP sensor? Could also be some type of mechanical load binding the drive or bad harness connection. The only time I have had this error was a defective shift motor.
rickg never answered that and therefore never got any help with his problem.
He's gone fishing.
this is a treat of 2010 ??????????
Bookmarks