Hi everyone,
The copier does not start up, the MAIN power light lights up but the ON light next to it does not. I do not have a screen. Does anyone know the order in which the power goes into the copier.
Hi everyone,
The copier does not start up, the MAIN power light lights up but the ON light next to it does not. I do not have a screen. Does anyone know the order in which the power goes into the copier.
Any noise upon power up, printer goes through initial boot up/warm up routine or is printer simply quite with the one power indicator on ?
Just quite, no start up
I had that happen one time. I ended up replacing the power supply PCB2 AZ250017, item 1 in the JPEG. You may want to verify the CB near the finisher on the left rear of the machine and reseat all cabling or possibly power up without any options connected, finisher, LCT, to verify problem is with the engine and not the options.
.PCB..JPG
Thanks I'll give that a try!
I was a little vague on the part about reseat all cabling. I should have said reseat all interface type cables, ADF, LCT, communications, etc-no internal cables. Sorry about that.
This Machine have two Extra powerswitch One on the side from Tonerbank and another in the middle of backside
down from the board, its possible u hit this one and finaly machine go to power but u dont have a touchpanel and u hear the processing dont beginn
look at this i saw this two times by engineers and show them this
all this machine works fine now
Bookmarks