MP 4000 web near end messsage.

[aabarnes1]

Hello chaps, can somebody advise me which sp mode will remove this irritating 'call service, fuser web nearly finished' . Thanks. Suffice to say it's nerly full and the counter was reset.

[tcs04]

Hello chaps, can somebody advise me which sp mode will remove this irritating 'call service, fuser web nearly finished' . Thanks. Suffice to say it's nerly full and the counter was reset.

Which counter?

Try this, set SP1-902 to "0" (Web counter to zero).... SP7-806-8 (Reset near end counter) reboot. If that doesn't work try SP5-810 (Fuser code reset) Then estimate the amount of web used and set SP1-902 to this value.

[zed255]

On these you should only have to reset the PM count for the web, assuming the firmware is up to date. The other values should automatically reset when the PM count is reset.

[tcs04]

Hello chaps, can somebody advise me which sp mode will remove this irritating 'call service, fuser web nearly finished' . Thanks. Suffice to say it's nerly full and the counter was reset.

I knew I was close but thought I may have missed something, so I checked Knowledgebase and under MP4000 / tier 2 / "web" in text search..........

Symptom]
Web near end message will not clear from the display.



[Action]

• When the display shows "Web End", perform reset for SP 7806-008.

• When the display shows "Web Near End", perform resets for both SP 7806-008 and also SP 7804-005.

• ...............AHA!!!!....... What do we know!?

There IS a firmware update if yours is old, that stops the machine double counting the web.....

Symptom corrected:
When updating the Engine firmware from Ver1.01:05/Ver1.02:05 to Ver1.03:05, the
value of SP7-803-011(PM counter rotation(%): Web) sometimes changes to an
abnormal value (twice the value of SP1-902-001(Cleaning Web Setting web

Consumption).